Resuming a Build

A PhotoMesh build process can be resumed in any of the following cases:

§  The initial build process was canceled by the operator in the middle.

§  Unexpected hardware or software failure occurred during the build causing the build to stop

To resume a build:

Note:    You can only resume a build when you are in Review mode for that build.

1.     If you are not in Review mode, on the Home tab, in the Review group, click Review Mode.

2.     On the Home tab, in the Process group, click the arrow under Build and select Resume Build.

Note:        If you want to create an entirely new build, see "Creating a New Build" in this chapter for information.